Simple Ways to Minimize the pH Levels in Your Pool

As the pool chemistry starts getting out of whack, it takes energy and time to restore their balance. pH levels are no exception here. A well-known pool repair company in OKC can handle things professionally. However, there are numerous ways to fix things on your own, at least to some extent.

According to the rule, a pH level from 7.4 to 7.8 is considered ideal for swimming pools. Anything higher than that and you are sure to hear complaints about dry skin and stinging eyes.

Before walking towards the solution, here are a few things to understand:

What pH Implies?

The pH level of water is a measurement of the balance between acidity and alkalinity. In simple terms, it indicates whether your swimming pool is alkaline or acidic.

A highly acidic pool irritates your eyes and skin and leads to etching on the surfaces. Likewise, excessive alkalinity makes the water cloudy and gives rise to scaling.

Why Minimize the Pool’s pH Balance?

Swimming pools with higher Ph levels are a threat to swimmers, causing some serious health problems while destroying the chlorine benefits.

Following are the problems you may encounter:

• Scaling

• Eye and skin irritation

• Increased demand for chlorine

• Clogging of pipes and filters

• Water getting cloudy

Scaling can slow down the movement of pipe water, which may eventually burn out the motor or cause damage to the pipes. This in turn increases the expenses of your repair bills.

Super-Effective Ways to Minimize pH Levels

Muriatic acid and sodium bisulfate are the two major chemicals that help in reducing the pH levels.

Warning- These chemicals can cause damage to your skin and pool surface. Hence you must use them with caution. (Wear clothes to cover your body completely, along with goggles and gloves). Or let the pool repair company in OKC handle the work.

Muriatic Acid- Also called hydrochloric acid, it is mostly used for commercial purposes like dissolving rock or pickling steel. Many people also use it to get rid of excess calcium buildup (acid washing). As it is a strong chemical you must use it cautiously.

Sodium Bisulfate- As it is mostly available in dry powdered forms, you should not use it during windy days. Although you need to use these carefully, they are quite milder than muriatic acid.

  • pH and alkalinity test- Make sure that the alkalinity lies between 80 to 120 ppm with the pH range of 7.2 to 7.6. If the levels are higher, these chemicals can lower them.
  • Follow the instructions- Read the instructions given in the pack for optimum use of the product.
  • Start adding the chemical- Add your preferred chemical to the return jet regions (the entrance points of pool water). For above-ground swimming pools, the water must be circulated and spread using your hands.
  • Let it dissolve- Let the chemical circulate through the filtration system.
  • Re-test- The alkalinity and pH levels should be rechecked in four hours. If the levels are still higher, repeat the process.

Put the Pool Problems at Bay

Looking for a dependable pool repair service in OKC? Hydroscapes Pools and Patios are ready to help. With more than 100 years of industry experience, we work hard in designing your dream backyard. Let our team take care of your pool requirements.